Owens Corning
Architectural shingles
Metal roofing
Tile roofing
GAF
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Owens Corning Roof Inspection in Fresno: What to Know First
An Owens Corning roof inspection in Fresno typically runs $195 – $395 for a full visual and physical walk of the roof surface, flashings, penetrations, and attic underside, and we can usually get a technician to your home within a few business days. We’re an independent Owens Corning service provider – not a manufacturer rep – so the report you get is straight about what your roof actually needs, with a written price before any work starts. If you own a Owens Corning system and you’re seeing stains, granules in the gutter, or a shingle lifting at the rake, call (559) 785-2160 and we’ll tell you what you’re looking at.
This page is for Fresno homeowners who have an Owens Corning roof and want an inspection that actually explains what’s happening up there – which series is failing, why, and what it costs to fix it right. Travis Oakley and our crew inspect Owens Corning systems every week here in the Valley, from the Tower District to Woodward Lake.
How Owens Corning Products Fail – and How We Fix Them
- Duration Series granule loss at the shingle butt edge. On Owens Corning Duration shingles, we see a specific pattern in Fresno: the SureNail strip holds fine, but the adhesive seal at the butt edge can lose bond after repeated 100°F-plus afternoon cycles, allowing the shingle corners to flutter. That flutter grinds granules off the bottom edge. During inspection, we check the seal integrity at the butt, not just the nail strip. Fix is resealing the affected shingle or section, not tearing the roof off.
- Oakridge Series cracking at the shingle’s fiberglass mat. Oakridge is a good shingle, but on older Fresno homes with limited attic ventilation, we see brittle cracks running vertically through the shim line. The mat dries out, and the shingle splits. Inspection includes pulling attic ventilation numbers – intake and exhaust – because Oakridge on a hot-box attic fails faster than the same shingle with proper airflow. We fix the ventilation first, then replace cracked shingles.
- Flashing failure at valley junctions on Owens Corning systems. This one is not Owens Corning-specific, but it shows up on almost every older OC roof we inspect in Fresno. Valley metal corrodes at the screw line, or step flashing pulls away at the wall transition. Water gets behind the underlayment and stains ceiling drywall. Our fix is removing and replacing the flashing with new metal, not caulking over it – caulk is a temporary band-aid under Valley sun.
- Hip and ridge cap loss on Duration and Oakridge roofs. Owens Corning hip and ridge caps are modular pieces. In high-wind Fresno storm events, we see caps lift and separate at the butt joint. Once one goes, the next one loosens. We inspect every cap joint by hand, and we replace missing caps with OC-approved substitutes so the warranty stays intact.
- Ventilation shortfall showing up as premature curl on the sun-side slope. The south-facing slope in Fresno takes a beating. We inspect both slopes separately because the south slope on any OC product – Duration, Oakridge, or Berkshire – curls first. Curl is a ventilation and heat problem, not a shingle defect in most cases. Fix is adding intake or exhaust ventilation before replacing the curled shingles.
Styles & brands we work with






Our Owens Corning Roof Inspection Process
- 1
Call and scheduling. You call (559) 785-2160, a live person answers – no voicemail, no call-back queue – and we schedule a window that works for you.
- 2
On-site walk and talk. Before we go up, we ask what you’ve been seeing: stains, granules, a leak after the last storm. Tell me what you’re seeing and I’ll tell you what it actually means.
- 3
Roof-surface inspection. We walk every slope, check shingle seals, flashing, pipe boots, ridge caps, and valley metal. We photograph what we find so you don’t have to take our word for it.
- 4
Attic inspection. We go into the attic to check the decking underside, ventilation numbers, and any water stains that don’t match what we saw on top.
- 5
Written report and a written price. We hand you a line-item inspection report and a written price for any work needed. That number goes on paper before any work starts, and it does not move at the door.
- 6
Repair, test, and clean up. If you approve the work, we do it with uniformed, background-checked technicians, then run water on the repaired area if it’s a leak, and we leave the job site clean. Every repair we do is covered by our 365-Day Done Right Promise – in writing, for one full year, and we come back for free if it fails.
See the difference
Before
After
Before
After
Before
AfterWhat Owens Corning Roof Inspection Costs in Fresno
Here’s the honest pricing posture we hold for Owens Corning roof inspection in Fresno:
- Inspection only (visual + attic): $195 – $295 depending on roof size and pitch
- Inspection with minor shingle or seal repairs: $350 – $550
- Inspection with flashing or pipe-boot replacement: $500 – $800
- Inspection with ventilation correction plus repairs: $800 – $1,400
The price moves based on roof pitch, the number of repairs, and whether we’re replacing flashing or just sealing. Steep roofs take longer and require more safety setup. The price you see in writing is the price you pay. Call (559) 785-2160 for a free estimate and we’ll get you exact numbers on paper.
Why Fresno Homeowners Call Brennan Roofing Co Fresno for Owens Corning Work
We built our reputation in Fresno on one thing: we do what we say we’ll do, and we put the price in writing before the first nail comes out. Every job – inspection, repair, or full replacement – runs under The Garrison Standard. That means background-checked, uniformed technicians on your roof, a written price before any work starts, and a 365-Day Done Right Promise in writing: if the repair fails within a year, we come back at no charge. No fine print, no dance.
We inspect Owens Corning systems every week, but we also install and service GAF and CertainTeed. That matters because it means we’re not married to one product line. If you need a part or a replacement shingle that Orange County can’t source, we have alternatives that won’t void your warranty. And when you call, a live person answers – around the clock, seven days a week.
FAQs
No. An independent inspection by Brennan Roofing Co Fresno does not void or alter your Owens Corning warranty. We are not an Owens Corning-authorized dealer, but we inspect and repair to the standard your warranty expects – and we use OC-approved materials when replacement is needed, so your coverage stays intact.
In most cases, yes. If the inspection turns up a lifted shingle, a failed seal, or a small flashing leak and the weather is safe, we can often complete the repair the same day. We carry common Owens Corning replacement shingles and compatible accessories on the truck. Call (559) 785-2160 and we’ll tell you what we can do.
The inspection answers that. If the shingles are granule-worn but still sealing and the decking is sound, you likely need targeted repairs and ventilation correction. If the shim line is cracked across the entire south slope and the decking is soft, replacement is the smarter money. We show you photos from the attic and the roof surface so you can see what we see.
No, and that’s the whole point of The Garrison Standard. The price goes on paper before any work begins, and it does not move. If we find something hidden during the repair that requires an extra part, we stop and we talk to you before adding a dollar. You never get a surprise invoice from us.
We guarantee the work we do, in writing, for one full year. If a repair we made fails within that year, we return at no charge. That’s our 365-Day Done Right Promise, and it applies to every Owens Corning inspection and repair we complete in Fresno.
Written by Travis Oakley, Owner, Brennan Roofing Co Fresno at Brennan Roofing Co Fresno, serving Fresno and nearby areas.