Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Styles & brands we work with
See the difference
Before
After
Before
After
Before
AfterValley Repair in Fresno, CA
Valley repair in Fresno addresses the specific failure points where two roof slopes meet, typically at the interior angle where water channels during our winter rain season. In the San Joaquin Valley, valley failures account for a significant share of the roof leaks we see, particularly on homes built in the 1980s and 1990s where valley metal has reached the end of its service life. If you’re seeing water stains on ceilings near the center of your home rather than along exterior walls, there’s a strong chance the valley is the culprit. Call Brennan Roofing Co Fresno at (559) 785-2160 and we’ll diagnose it right, with a written price before any work starts. For more on how valleys fit into the bigger picture, see our full Roof Repair in Fresno page.
When You Need Valley Repair
Valleys don’t fail quietly. They announce themselves through specific symptoms. Here’s what we see across Fresno neighborhoods from Woodward Park to Tower District:
- Water stains on ceilings in the center of the house – Not near exterior walls. Valleys drain toward the middle of the roofline, so leaks show up in hallways, kitchens, or living rooms rather than perimeter rooms.
- Visible rust or corrosion on valley metal – Fresno’s summer heat bakes valley metal, and winter rain cycles accelerate corrosion. If you can see rust from the ground or from a window, the metal is compromised.
- Granule buildup in gutters directly below a valley – Valley channels concentrate water flow, which carries shingle granules with it. Heavy granule loss in one specific downspout area points to a valley issue.
- Shingles lifted or missing along the valley line – The valley collects more than water. Debris from Fresno’s oak trees and wind-blown material scours the valley edges and can lift shingles.
- Water stains on attic sheathing along an interior slope line – If you go into the attic with a flashlight and see dark water trails running down the sheathing along a diagonal line, that’s valley leakage.
- Previous valley repair with roofing cement or tar – We find a lot of Fresno homes where someone slapped cement over a valley leak as a stopgap. It fails within a season or two. It needs to be redone properly.
Our Valley Repair Process
Every valley repair follows the same sequence. We don’t improvise. The Garrison Code applies to a $400 valley patch the same way it applies to a full home roof replacement.
- Inspection and diagnosis – We climb up, pull back the shingles along the valley edge, and determine whether the valley metal itself is failing, the underlayment beneath it is shot, or the shingles are the problem. We document with photos.
- Written price before anything starts – You get the number on paper first. It doesn’t move at the door, and it doesn’t change halfway through the job. If we find something unexpected, we stop and talk to you before proceeding.
- Decking evaluation – We check the roof decking (the plywood or OSB layer under everything) where the valley drains. Fresno’s summer heat expands and contracts decking, and a valley leak can rot a three-foot section without being visible from below. If decking needs replacement, that’s priced separately and clearly.
- Removal of compromised material – We pull the damaged valley metal, underlayment (the waterproof membrane under the shingles), and any rotted decking. We cut back shingles cleanly on both sides of the valley line.
- New underlayment and valley metal – We install new underlayment first, then new valley metal. The type of metal depends on your roof’s material, but it’s always installed with proper overlap and fasteners placed outside the water channel. No exposed fasteners in the valley itself – that’s a rookie error that leaks within months.
- Shingle replacement and sealing – We weave or lap the shingles back into the valley per the manufacturer’s spec for your shingle type, then check the drainage path with a water test before we leave.
The whole process typically takes a half-day to a full day depending on valley length and decking condition. You get the 365-Day Done Right Promise in writing before we leave: if it fails within a year, we come back and fix it at no charge.
Valley Repair Pricing in Fresno
Valley repair in Fresno typically runs $350 to $1,800 depending on length, decking damage, and material. That’s an honest range. Here’s the breakdown:
- Valley metal replacement on a shorter run – $350 to $650. This covers one valley under about 12 feet with minor shingle work.
- Standard valley repair with underlayment – $550 to $950. This covers one valley with full underlayment replacement and shingle weaving on both slopes.
- Decking repair added – $300 to $700 per section depending on rot extent. We price this separately and clearly.
- Full valley replacement on steep or long valleys – $1,100 to $1,800. Longer runs, harder access, or two-story homes push the cost up.
- Material upgrades – We can use higher-spec valley metals if your roof uses premium shingles from GAF, CertainTeed, or Owens Corning. The upgrade cost depends on the material, and we’ll show you the numbers before you choose.
What affects cost? Valley length is the big one. A long valley on a Ranch-style home in Clovis costs more than a short valley on a two-story Fowler home with steeper access. Decking damage is the wildcard – we can’t see under the valley until we pull up the old material, so the written estimate includes a decking contingency clearly stated. No surprise line items. No “while we’re up there” game.
We install valleys using materials from manufacturer lines including GAF, CertainTeed, and Tamko, matched to your existing roof so the repair blends and drains correctly. Call (559) 785-2160 for a free estimate. The price goes on paper before any work begins, and it stays on paper afterward.
Why Valley Repair Gets Botched in Fresno
We see the same failed valley repairs across Selma, Kerman, and Sanger, and the causes are consistent. It helps to understand what goes wrong so you can spot it before you hire.
First, exposed fasteners in the valley metal. A roofer drives a nail or screw right through the valley liner to hold it down, which creates a water entry point at the exact spot that channels the most runoff. It leaks again in six months. Second, no underlayment replacement under the valley. The valley metal might be new, but the rotted felt or synthetic membrane beneath it still lets water soak into the decking. Third, wrong valley profile for the water volume. Fresno’s winter storms can dump an inch an hour, and a W-profile valley needs a wider water channel than a V-profile on a steeper slope. If the geometry is wrong, water backs up under the shingles during heavy rain.
The Garrison Standard exists because we saw this pattern too many times. We pull up the valley, inspect what’s underneath, document it, and show you what we’re doing before we close it back up.
FAQs – Valley Repair
How much does valley repair cost in Fresno?
Valley repair in Fresno costs $350 to $1,800 depending on valley length, decking damage, and material choice. Most single-valley repairs land between $550 and $950. Call (559) 785-2160 for an exact quote – estimates are free and the price goes in writing before any work starts.
Can you repair a valley without replacing the whole roof?
Yes, valley repair is a targeted fix that does not require replacing the entire roof, as long as the surrounding shingles are in decent condition and the decking beneath the valley is structurally sound. We pull back shingles just along the valley line, replace the valley metal and underlayment, and weave the shingles back in. If the decking is rotted or the shingles are too brittle to work with, we’ll show you photos and give you a straight answer about whether a larger repair like Vent Boot Repair or flashing work makes more sense.
How long does a valley repair take?
Most valley repairs in Fresno take half a day to one full day. Steeper roofs, longer valleys, or decking replacement extend that to a full day and sometimes into the next morning. We’ll give you a clear timeframe when we hand you the written estimate, and our technician shows up inside the promised window.
Will your valley repair match my existing roof?
We match valley metal and shingles to your existing roof as closely as possible, sourcing from manufacturer lines that include GAF, CertainTeed, and Tamko. Color matching is usually straightforward if the roof is less than 10 years old; older roofs may have slight color variation due to weathering. We’ll tell you honestly before we order materials. You get the 365-Day Done Right Promise in writing regardless.
Valley repair is not a place to cut corners. Water travels the valley every time it rains, and a failed valley means water inside your home at the exact spot you can’t easily see until the ceiling stains. Call (559) 785-2160 for a free estimate from Brennan Roofing Co Fresno. A live person answers, 24/7. No voicemail, no callback queue. We’ll schedule the inspection, put the price on paper, and if you choose us, a background-checked technician in uniform gets on your roof and does it right.
Written by Travis Oakley, Owner at Brennan Roofing Co Fresno, serving Fresno.
If you’re dealing with broader roof issues beyond the valleys, our Roof Repair in Fresno page covers the full scope of what we fix, from flashing to full roof replacement.